Steps
Place the palm-rest and keyboard assembly on a flat and clean surface and perform the post-requisites to install the palm-rest and
keyboard assembly.
NOTE: Install the solid-state drive mounts on slot one and two from the old palm-rest and keyboard assembly into the new
palm-rest and keyboard assembly.
Next steps
1. Install the power button.
2. Follow the procedure from step 6 to step 25 in Installing the system board.
3. Install the keyboard-controller board.
4. Install the
display assembly.
5. Install the touchpad.
6. Install the power-adapter port.
7. Install the speakers.
8. Install the battery.
9. Install the rear-I/O cover.
10.Install the
wireless card.
11. Install the M.2 2230 solid-state drive or M.2 2280 solid-state drive in slot one, whichever applicable.
12. Install the M.2 2230 solid-state drive or M.2 2280 solid-state drive in slot two, whichever applicable.
13. Install the memory module.
14. Install the base cover.
15.Follow the procedure in After working inside your computer.
67
To Next Page
Loading...
