Alinco DJ-G5T/E User Manual

Guide to inserting and removing the rechargeable Ni-Cd battery pack from the transceiver.

Covers powering the transceiver on/off and adjusting audio volume and squelch levels.

Explains how to designate and switch between the main and sub bands for operation.

Describes the VFO, Memory, and Call modes of operation.

Guide to entering and adjusting frequencies using VFO mode.

Provides steps to improve reception of weak or intermittent signals.

Instructions for transmitting signals using the main band of the transceiver.

Explains how to allocate and use the PTT2 key for special transmission functions.

Details on managing memory channels for storing frequencies and settings.

How to program memory channels using VFO mode settings.

How to program memory channels directly in memory mode.

Overview of scan functions: Band, Programmed, and Memory scans.

How to initiate and stop scanning across the entire frequency band.

Scanning between specific programmed memory frequencies.

Scanning through programmed memory channels.

Function for monitoring signal levels of surrounding frequencies.

Using Channel Scope in VFO mode to monitor frequencies around the center.

Using Channel Scope in memory mode to monitor programmed channels.

Function to scan and display signal levels across frequency ranges.

Monitors a priority channel while receiving the main frequency.

Guide to configuring the transceiver for repeater communication.

Transmits received signals on the other band (DJ-G5T only).

Unmutes squelch only for signals with a specific tone frequency.

Unmutes squelch based on sending and receiving DTMF codes.

Lists common symptoms, their causes, and suggested actions for resolution.

Procedures for resetting transceiver settings to factory defaults.