11
Basic Operations
Transmitting Tone BURST TONE
Transmitting OPTIONAL SIGNALING
Press and hold [PTT] key, then press Microphone key to transmit
selected tone-burst tone. Pre-programming is necessary.
Press and hold [PTT] key, then press Microphone
key to
transmit pre-stored and selected DTMF/2Tone/5Tone optional signaling.
Preprogramming is necessary.
MEMORY CHANNEL PROGRAMMING
MEMORY CHANNEL DELETING
1.
In frequency mode (VFO), select the desired frequency.
2.
Press
P3
key to enter CTCSS/DCS signaling setup, press microphone
or key to select the desired signaling in case you need.
See next page for more details.
3.
Press
FUNC
key, LCD appears ,
and
current channel appear on LCD. Flashing
means the current channel is empty.
4.
Press or Key to select the
desired channel number to store.
5.
Press key, , icon and channel
number disappears and beep sounds twice.
6.
Press key again to confirm that the memory channel is properly
stored.
1.
Under Memory mode, input by MIC's numeric keys to select
channel to be deleted. For example, choosing CH1, press [0] [0] [1].
2.
Press
FUNC
key, LCD appears icon, then press
P2
key, current
memory will be deleted and a beep sounds twice.
icon ashing
means current memory channel is deleted. Can not delete all
memory channels, at least one channel will be saved.
4
While transmitting, LED lights RED and TX-meter shows relative power level.
Release PTT to receive.
Speaking too loud distorts, too undertone won't modulate enough your
voice.
To Next Page
Loading...
