Alinco DR-CS10 - Function Menu Setup; APO (Auto Power Off); DTMF Transmitting Time; Display Illumination Color Setting

20
DTMF Transmitting Time
1.
Press and hold
FUNC
key for over 2
seconds to enter setting menu.
2.
Press
P3
/
P4
key to choose No.19
menu, LCD displays "SPD--50".
3.
Press / to select the desired setting, in miliseconds.
30/50/100/200/300/500, which indicates the time for sending each
DTMF signal & the interval between each DTMF being sent.
4.
Press
P2
key to confirm and exit.
FUNCTION MENU SETUP
7
Display iiiumination color setting
This is to select the display illumination color.
1.
Press and hold
FUNC
key for over 2 seconds to enter setting menu.
2.
Press
P3
/
P4
key to choose No.20 menu, LCD displays "COL--
ORG".
3.
Press / to select the desired color.
ORG: Orange backlight
SAK: (Sakura) light pink backlight
WHI: White backlight
OFF: NO backlight
4.
Press
P2
key to confirm and exit.
Scan resume Time Setup
There are 3 kinds of scan resume conditions.
1.
Press and hold
FUNC
key for over 2
seconds to enter setting menu.
2.
Press
P3
/
P4
key to choose No.21
menu, LCD displays "SCAN--TO".
3.
Press / to select the
desired Scan Resume Time.
TO: Timed Scan, it resumes scanning
after receiving 5 seconds or when the
signal is gone, which ever faster.
CO: Busy Scan, it resumes scanning when the receiving signal is
gone.
SE: Stops scanning when a signal is received.
APO (Auto power off)
Once APO is activated, the radio will be automatically switched off when
the pre-set time is elapsed.
1.
Press and hold key for over 2
seconds to enter setting menu.
2.
Press
P3
/
P4
key to choose No.18
menu, LCD displays "APO--OFF".
3.
Press / to select the
desired setting.
30MIN:Auto power off after 30m
1HOUR:Auto power off after 1h
2HOUR:Auto power off after 2h
OFF:Disable Auto power off
4.
Press
P2
key to confirm and exit.