Alinco DR-CS10 - Function Menu Setup; Frequency Step Setup; Receiving DTMF, DTMF ANI, 2 Tone or 5 Tone Signaling

15
2.
Press
P3
/
P4
key to choose No.01 menu, LCD displays "STP--
125".
3.
Press / to select the desired frequency channel step.
Available steps in KHz are: 2.5(shown as 2K5), 5, 6.25(62), 8.33(83),
10, 12.5(125), 20, 25, 30 and 50.
4.
Press
P2
key to confirm and exit.
1.
Press and hold
FUNC
key for over 2
seconds to enter setting menu.
1.
Press and hold
FUNC
key for over 2 seconds to enter the FUNCTION
MENU SETUP.
2.
Press
P3
or
P4
to select the desired menu.
P3
key to forward
and
P3
key to backward menus.
3.
Press / to select the desired parameter.
4.
Press
P2
to confirm and exit.
Only in VFO mode, this function is valid.
7
FUNCTION MENU SETUP
Frequency Step Setup
This function is not available in memory-mode.
RECEIVING DTMF, DTMF ANI, 2TONE OR 5TONE SIGNALING
DTMF/5Tone/2Tone signalling are used for selective-calling. DTMF
and 5Tone signalling can be applied for other advanced features such
as ANI, PTT ID, group call, remotely stun, remotely kill, revive,...etc.
The signalling edition must be done in advance to operates through
programming software.
1.
Press and hold
FUNC
key for over 2 seconds to enter into setting
menu.
2.
Press
P3
/
P4
to choose No. 2 menu, LCD displays "T-OFF" .
3.
Press / to select the desired setup.

"DTMF”: The channel will be mute by a DTMF signal. The
speaker won’t sound until receiving
a correspondent DTMF signal. Hold
[PTT] then press [UP] directly to
transmit the pre-stored DTMF tones.
IMPORTANT: All or a part of operation in this chapter may not be
available to dealer-programmed units.
Menu No. LCD Display
Å
Default
01 STP (Channel Step) 12.5K
02 T (DTMF,2 TONE, 5 TONE Of RX) OFF
03 2TONE (TX) 00
04 5TONE (TX)
00
05 DTMF (TX) 01
06 SPK (Signal Combination) SQ
07 POWER HIGH
08 BAND 25K
09 TX ON
10 LOCK(Busy Channel Lock Out) OFF
11 Editting Channel Name -
12 REV (Reverse TX/RX) OFF
13 TALK (Talk Around) OFF
14 D (DTMF Self ID Enquiry) 001
15 F (5 TONE Self ID Enquiry) 12345
16 BEEP (Beep Sound) ON
17 TOT (Time Out Timer) 3 Minutes
18 APO (Auto Power Off) OFF
19 SPD (DTMF Transmitting Time) 50
20 COL (Display Color) ORG
21 SCAN T0
22 TB (Tone-Bust Tones) 1750
23 DSP (Display Mode Setup) FR
24 CODE OFF
25 BOOK (Address List) -
26 RESTORE -