Alinco DR-CS10 - Microphone Operation; Talk Around; Beep Sound; High;Mid;Low Power Selection

25
8
Talk Around
By Talk Around function, you can directly communicate with other radios
in your group in case the repeater is not activated or when you are out of
the repeater range. The transceiver will transmit by RX frequency with its
CTCSS/DCS signaling.
1.
In standby, press , then press key, LCD displays "TALK--
OF".
2.
Press [ / ] to select the desired setting .
ON:Enable Talk Around
OFF:Disable Talk Around
3.
Press number key to confirm and exit.
BEEP sound
The prompting tone provides confirmation of entry, error status or
malfunctions of the transceiver. You can enable or disable this function.
1.
In standby, press , then press , LCD displays "BEEP--XX”.
2.
Press [ / ] to turn on/off BEEP prompt.
BEEP—OF: turn off the beep;
BEEP—ON: turn on the beep.
HIGH/MID/LOW Power Selection
1.
In standby, press , then press , LCD displays "POW-XX".
2.
Press [ / ] to select the desired power.

LCD displays icon, it indicates CTCSS encode set in current
channel.

LCD displays and icon, it indicates CTCSS encode and
decode set in current channel.

LCD displays DCS icon, it indicates DCS encode and decode set
in current channel.
3.
In corresponding icon, press [ / ] to select the desired
CTCSS/DCS encode and decode.
4.
Press , , or to confirm and exit.
3.
Press number key to confirm and exit.
HI:High Power
MI:Middle Power
LOW:Low Power
3.
Press number key to confirm and exit.
LCD Backlight
1.
In standby status, press , then press LCD displays "COL-
XX" .
2.
Press [ / ] to select desired backlight.
ORG:Orange backlight
SAK: Sakura backlight (bright pink)
WHI:Whilt backlight
OFF:No backlight
3.
Press number key to confirm and exit.
Microphone Operation