ALKOTA 4142 - SAFETY INSTRUCTIONS; INSTALLATION GUIDELINES; OPERATION PROCEDURES; COMBI OPERATION (OPTIONAL)

2
OPERATION TABLE OF CONTENTS
ELECTRIC DRIVEN OIL FIRED CLEANER
SAFETY INSTRUCTIONS Page Number
• Safety Symbols 3
• General 3
• Mechanical 4
• Electrical 4
• Fuel 5
INSTALLATION
• Location 5
• Electrical 6
• Extension Cord 6
• Venting 5
• Water Supply 5
• Barrier 5
• Water Conditions 5
• Freezing 5
• Cold weather 5
• Chemicals 5
VENTING
• Draft Diverters 6, 7
• Venting Installation Information 7
OPERATION
•Pre Start-Up 7
•Start-Up 8
•To Clean, Apply Chemical, To Rinse 9
•Shut Down 9
COMBI OPERATION (OPTIONAL)
•Pre Start-Up 10
•Start-Up 11
•To Clean, Apply Chemical, To Rinse 11
•Shut Down 11
MAINTENANCE
Machine
• Spray Tip Maintenance 12
• Belt Tension 12
• Coil Back Pressure 12
• Schedule 14
• Flushing, Storage 13
Burner
• Fuel Pump Screen See Parts List Section
• Transformer Check See Parts List Section
• Burner Gun Remove/Replace See Parts List Section
• Blower Fan Remove/Replace See Parts List Section
Fuel Filter Page Number
• Maintenance See Parts List Section
TROUBLESHOOTING
•Machine 16, 17
• Water Heater 15
• Oil Burner See Parts List Section
• Pump See Parts List Section
• Fuel Filter See Parts List Section
SERVICE
• Pump See Parts List Section
• Fuel Filter See Parts List Section
• Trigger Gun See Parts List Section
• Unloader See Parts List Section
• Machine Breakdown See Parts List Section
COMPONENT ADJUSTMENT
Burner
• Air Band Adjustment See Parts List Section
• Buss Bar Alignment
See Parts List Section
• Electrode Ass’y Adjustment
See Parts List Section
Chemical Metering Valve
See Parts List Section
Temperature Control (If So Equipped)
See Parts List Section
Unloader Valve
See Parts List Section
WARRANTY Inside Back Cover
SPECIFICATIONS Inside Front Cover
SCHEMATIC Last Page
Supersedes 08-19-05 Z08-03940TC 07-05-06 Z08-03940TC