3
SAFETY, INSTALLATION, AND OPERATION
ELECTRICAL DRIVEN OIL FIRED CLEANER
GENERAL SAEFTY
Supersedes 08-19-05 Z08-03940 07-05-06 Z08-03940
Read and understand this “OPERATOR’S
MANUAL” and “LABELS
ON THE MACHINE” before
starting.
WARNING: The discharge reaching over
125° F can cause SERIOUS BODILY INJURY to
you and anyone coming in contact with it.
La décharge atteignant par-dessus 125° F peut
causer LA BLESSURE PHYSIQUE SERIEUSE à vous
et n'importe qui entrant le contact avec cela.
La expulsión de que es más de125°F puedo hacer
un lesión de grave a Usted o alguien quien usar
esto equipo.
1. Before operating this machine, read and observe all
safety, unpacking, and operating instructions.
Failure to comply with these instructions could
create a hazardous situation.
2. The operator of this equipment should not operate this
equipment when fatigued or under influence of
alcohol or drugs.
3. The operator of this equipment should be
thoroughly familiar with its operation and trained
in the job to be accomplished.
4. The operator of this equipment should wear
protective face shields and other protective
clothing as required for safe operation.
5. Keep all protective covers and shields in place.
Operating this machine with moving parts could
allow operator or bystander serious injury or even
death.
6. Do not operate the machine if any mechanical
failure is noted or suspected. Keep all shields in
place.
7. Do not leave this machine unattended when it is
operating.
8. All installations must conform to all applicableLocal
codes. Contact your electrician, plumber, utility
company or seller for details.
9. If a water leak is found, DO NOT OPERATE THE
MACHINE. Shut off the motor and repair.
10. Follow instructions on how to stop the machine and
bleed pressures quickly. Be thoroughly familiar with
the controls.
11. When starting a job, survey the area for possible
hazards and correct before proceeding.
12. If chemicals are used in conjunction with this
equipment, read and follow the product label directions.
13. During normal operation of this machine, HOT
discharges and surfaces may be produced.
MACHINE UNPACKING
ALL CLEANERS ARE CAREFULLY INSPECTED AND
CARTONED TO PROTECT AGAINST SHIPPING
DAMAGE. IF THERE IS DAMAGE OR MISSING PARTS,
THE TRANSPORTATION COMPANY AGENT SHOULD
MAKE A NOTATION TO THAT EFFECT ON THE BILL.
REFER TO THE PARTS LIST IN THIS MANUAL AND
ADVISE WHAT PARTS ARE MISSING OR DAMAGED.
IF AVAILABLE, GIVE THE INVOICE NUMBER ON ALL
ORDER BILLS. THIS PROCEDURE WILL ENABLE
NEEDED PARTS TO BE SHIPPED QUICKLY.
READ ALL Installation, Operation, and Maintenance
instructions before operating the machine.
NOTE: Refer to CLEANER MODEL for SERIAL NUMBER
location.
NOTE: Dimensions are in inches unless otherwise note.
The safety alert symbol. This symbol is used to
identify safety information about hazards that can result
in personal injury.
A signal word (DANGER, WARNING, or CAUTION) is used
with the alert symbol to indicate the likelihood and the
potential severity of injury. In addition, a hazard symbol
may be used to represent the type of hazard
DANGER indicates a hazard which, if not avoided,
will result in death or serious injury.
WARNING indicates a hazard which, if not avoided,
could result in death or serious injury.
CAUTION indicates a hazard which, if not avoided,
might result in minor or moderate injury.
CAUTION, when used without the alert symbol,
indicates a situation that could result in damage to
the equipment.
IMPORTANT SAFETY
INSTRUCTIONS
To Next Page
Loading...
