3–6 Configuration and Interfacing
Publication 1203–5.1 –– July, 1997
Figure 3.4
Typical Programmable Controller Configuration for 1305 and 1336
PLUS/FORCE with Block Transfer
Block Transfer
Logic Status
Feedback
WORD 3
WORD 4
WORD 5
WORD 6
WORD 7
Output Image
Block Transfer
Logic Command
Reference
WORD 3
WORD 4
WORD 5
WORD 6
WORD 7
Remote I/O
Communications
Module
Input Image
SW3
1336 PLUS/FORCE
Controller
Programmable Controller
I/O Image Table
Data In A1 Data
In A2
Data In B1
Data In B2
Data Out A1
Data Out A2
Data Out B1
Data Out B2
Datalink A
Datalink B*
Datalink A
Datalink B*
Parameters
*NOTE: Datalink B has been truncated on a
1/4 rack boundary. Only the first word of Datalink B is
transferred. This configuration requires a
minimum rack size of 3/4 rack.
SW3
12345678
OPEN
Logic Cmd/Sts On
Block Transfer On
Reference/Feedback On
Datalink A On
Datalink B On
Datalink C Off
Datalink D Off
Truncate Last Datalink On
AB0506A
To Next Page
Loading...
