4 POINT I/O 4 Channel IO-Link Master Module
Publication 1734-IN043A-EN-E - September 2015
ATTENTION: This product is grounded through the DIN rail to chassis ground.
Use zinc plated yellow-chromate steel DIN rail to assure proper grounding. The
use of other DIN rail materials (for example, aluminum or plastic) that can
corrode, oxidize, or are poor conductors, can result in improper or intermittent
grounding. Secure DIN rail to mounting surface approximately every 200 mm
(7.8 in.) and use end-anchors appropriately.
ATTENTION: Do not remove or replace an Adapter Module while power is
applied. Interruption of the backplane can result in unintentional operation or
machine motion.
ATTENTION: To comply with UL restrictions, this equipment and all connected
I/O must be powered from a source compliant with the following:
Safety Extra Low Voltage (SELV)
ATTENTION: To comply with CE Low Voltage Directive (LVD), this equipment
and all connected I/O must be powered from a source compliant with the
following:
Safety Extra Low Voltage (SELV)
ATTENTION: Do not wire more than 2 conductors on any single terminal.
To Next Page
Loading...
Need help?
General
