Allen-Bradley 1734-AENT User Manual

1734 POINT I/O EtherNet/IP Adapter 9
Publication 1734-IN042D-EN-P - October 2015
Install the Adapter
Follow this procedure to install the adapter on the DIN rail.
Mount the POINT I/O EtherNet/IP Adapter on a DIN Rail
Position the I/O adapter vertically above the DIN rail. Make sure that the DIN rail lock is
in horizontal position.
1. Position the adapter module on an IEC standard (35 x 7.5 x 1 mm) top-hat DIN
rail at a slight angle (DIN rail: Allen-Bradley part number 199-DR1; 46277-3;
EN50022).
ATTENTION: You must only use Series C POINT I/O modules with 1734-AENT
EtherNet/IP Adapters. Series A or Series B POINT I/O modules will not work
with 1734-AENT EtherNet/IP Adapters (does not apply to POINTGuard
modules).
1734-AENT Series B
Module
Status
Network
Activity
Network
Status
Point Bus
Status
System
Power
Field
Po
w
e
r
POINT I O
75.30
(2.96)
74.00
(2.91)
132.72
(5.23)
52.23
(2.06)
35.55
(1.40)
A
B
45174
A = DIN rail
B = Secure DIN rail approximately every 200 mm (7.8 in.)

Allen-Bradley 1734-AENT Specifications

General

Product Type	EtherNet/IP Adapter
Network Protocol	EtherNet/IP
Enclosure Type Rating	None (open-style)
Storage Temperature	-40 to 85 °C (-40 to 185 °F)
Housing Material	Plastic
Operating Temperature	0 to 55 °C (32 to 131 °F)
Current Draw @ 24V DC	100 mA maximum
Network Address	Configurable via software
Ports	1 Ethernet port