10 POINT I/O 4 Channel Analog Current Output Module
Publication 1734-IN034C-EN-E - August 2016
1734-TOP Base
1. Using a bladed screwdriver to rotate the keyswitch on the mounting base
clockwise until the number required for the type of module being installed aligns
with the notch in the base.
2. Make certain the DIN rail locking screw is in the horizontal position.
You cannot insert the module if the locking mechanism is unlocked.
3. Insert the module straight down into the mounting base and press to secure.
The module locks into place.
Turn the keyswitch to align the
number with the notch.
Notch position 4 is shown.
Make sure the DIN-rail locking
screw is in the horizontal position.
44228
To Next Page
Loading...
