Allen-Bradley 22C-D072A103

Rockwell Automation Publication 22C-UM001J-EN-E - January 2017 105
Programming and Parameters Chapter 3
d319 [Testpoint Data] Related Parameter(s): A196
The present value of the function selected in A196 [Testpoint Sel].
Values Default: Read Only
Min/Max: 0/FFFF
Display: 1 Hex
d320 [Control SW Ver]
Main Control Board software version.
Values Default: Read Only
Min/Max: 1.00/99.99
Display: 0.01
d321 [Drive Type]
Used by Rockwell Automation field service personnel.
d322 [Output Speed] Related Parameter(s): P034
Displays current output frequency in percent (%). The scale is 0% at 0.00 Hz to 100.0% at P034 [Maximum Freq].
Values Default: Read Only
Min/Max: 0.0/100.0%
Display: 0.1%
d323 [Output RPM] Related Parameter(s): A199
Displays current output frequency in RPM. The scale is based on A199 [Motor NP Poles].
Values Default: Read Only
Min/Max: 0/24000 RPM
Display: 1 RPM
d324 [Fault Frequency] Related Parameter(s): b001
Displays the value of b001 [Output Freq] when the last fault occurred.
Values Default: Read Only
Min/Max: 0.00/320.00 Hz
Display: 0.01 Hz
d325 [Fault Current] Related Parameter(s): b003
Displays the value of b003 [Output Current] when the last fault occurred.
Values Default: Read Only
Min/Max: 0.0/(Drive Rated Amps × 2)
Display: 0.1 Amps
d326 [Fault Bus Volts] Related Parameter(s): b005
Displays the value of b005 [DC Bus Voltage] when the last fault occurred.
Values Default: Read Only
Min/Max: 0/820 VDC
Display: 1 VDC