248 Rockwell Automation Publication 2080-UM002K-EN-E - March 2019
Appendix C Quickstarts
On Micro850 and Micro870 controllers, users can use flash update their
controllers through the Ethernet port, in addition to the USB.
To begin, launch the Connected Components Workbench software:
1. In the menu, select Device -> Update Firmware -> Upgrade or
Downgrade...
Alternatively, in the Project Organizer, right-click the controller and select
Update Firmware -> Upgrade or Downgrade...
2. If your project does not have a connection path to the controller, the
Connection Browser dialog appears. Select your controller, then click OK.
3. In the Upgrade or Downgrade Firmware dialog box, select the desired
Target Revision to flash update the controller.
To successfully flash update your controller over USB, connect only one
controller to your computer, and do not perform the flash update in a
virtual machine such as VMware.
Flash update over USB using FTLinx software with a 32-bit operating
system is not supported. Use either a 64-bit operating system or RSLinx
Classic software.
To Next Page
Loading...
Need help?
General
