Publication 2711P-UM001A-EN-P
Using Configuration Mode 4-27
Configuration Mode
The Configuration Mode Options screen specifies whether the
PanelView Plus will boot up in Configure Mode:
• with the current application loaded.
• with the communication configuration of the current application
or the terminal’s RSLinx communication configuration.
If you select Yes to replace the terminal’s communication
configuration with that of the application, any changes made to
the device addresses or driver properties in the RSLinx
Communications screen will be lost.
These options are available only if an application is loaded in the
terminal. If an application is not loaded, both options are disabled and
set to No.
Run Options
The Run Options screen specifies whether or not:
• to replace the terminal’s communication (RSLinx) settings with
application settings when the application is run.
If you select Yes, any changes to the device addresses or driver
properties in the RSLinx Communications screen will be lost
when the terminal boots up.
• to delete log files (data, alarm history, alarm status) generated by
the terminal from the System Default location before running the
application.
Configuration Mode
Run Options
AB PLCs
To Next Page
Loading...
Need help?
General
