Rockwell Automation Publication 520-UM001G-EN-E - September 2014 139
Programming and Parameters Chapter 3
CustomView Parameter
Group
CustomView allows you to quickly access only the parameters needed for your
application by storing them in a custom parameter group. Add your frequently
used parameters to this group, then hide all other parameters with A552
[Program Lock] to simplify your drive configuration process.
Up to 100 parameters can be stored in the CustomView parameter group. You
can copy one entire AppView parameter group to the CustomView parameter
group as shown on page 138
or add individual parameters as show below.
To delete parameters from the CustomView parameter group:
Step Key(s) Example Displays
1. Press the Up Arrow or Down Arrow to scroll to
the CustomView group (GC).
2. Press Enter to view the parameters that can be
added to the CustomView group.
3. Press the Up Arrow or Down Arrow to scroll
through the list of parameters.
4. Press Enter to add the parameter to the
CustomView group. The LCD display will show a
confirmation.
Step Key(s) Example Displays
1. Press the Up Arrow or Down Arrow to scroll to
the CustomView group (GC).
2. Press Enter to view the parameters that are in
the CustomView group.
3. Press the Up Arrow or Down Arrow to scroll to
the command GC---.
4. Press Enter or Sel to view the parameters that
are stored in the CustomView group.
5. Press the Up Arrow or Down Arrow to scroll
through the list of parameters.
6. Press Enter to delete the parameter from the
CustomView group. The LCD display will show a
confirmation.
The Connected Components Workbench software can be used to speed up this
process with drag and drop functionality.
F
W
D
F
W
D
PROGR
A
M
F
W
D
F
W
D
F
W
D
F
W
D
F
W
D
PROGR
A
M
F
W
D
To Next Page
Loading...
Need help?
General
