What to do if Allen-Bradley Controller shows Motor Overload?
If the Allen-Bradley Controller displays a 'Motor Overload' message, it indicates that the motor load is excessive. Reduce the load to ensure the drive output current does not exceed the current set by [Motor NP FLA].
Why does my Allen-Bradley powerflex 700 show OverVoltage?
The Allen-Bradley Controller might show an 'OverVoltage' error due to high AC line voltage or transient conditions. It can also be caused by motor regeneration. To address this, monitor the AC line, extend the deceleration time, or install a dynamic brake option.
General| Series | PowerFlex 700 |
|---|---|
| Category | AC Drive |
| Input Voltage | 200-240V AC, 380-480V AC, 500-600V AC |
| Enclosure | Type 1 |
| Control Method | Sensorless Vector |
| Communication | EtherNet/IP, ControlNet, DeviceNet, PROFIBUS DP, Modbus |
To Next Page