Publication 2711-UM014B-EN-P
Configuring the Terminal 3-17
Configuring Presets
Select Preset Operations from the Configuration Mode menu to set the
values of control objects after a reset or power cycle. You can set
presets to:
• values provided by the PanelView application or
• last values entered from terminal prior to a reset or power
down.
Power-Up with Presets or Last States
Displays the current power-up selection. Use the up and down arrow
keys on keypad terminals (or the up and down keys on touch screen
terminals) to select an option. The selection takes effect the next time
the terminal is powered on.
• Select Presets to load initial values of control objects (into
controller data tables) with values supplied by the application.
• Select Last States to load initial values of control objects (into
controller data tables) with values entered at the terminal prior
to a terminal reset or power down.
Restart Unit and Load Values
Loads the values selected in the Power-Up With list and resets the
terminal.
Key Repeat Rate
Specifies the number of repeats that occur per second when a key is
pressed and held. Steps through key repeat rates: 0 (disabled), 200ms
(5 times/sec), 250ms (4 times/sec), 330ms (3 times/sec), 500ms (2
times/sec), 1000ms (1 time/sec).
Key Repeat Delay
Specifies how long a key must be pressed before it is repeated. Steps
through delay rates: 200ms, 400ms, 600ms, 800ms, 1000ms, 1500ms,
2000ms, 2500ms.
Exit
Returns to the Configuration Mode menu.
PRESET OPERATIONS
Last States
Presets
Key Repeat
Rate
1000 ms
F7
Key Repeat
Delay
200 ms
F15
Restart Unit
And
Load Values
F1
Power Up With:
F16
EXIT
To Next Page
Loading...
Need help?
General
