Addressing Reference
SLC 500 Family of Programmable Controllers
2
For specific information about the content of data table files, consult the:
PLC programmer, who assigns data to specific memory locations
SLC 500 Fixed Hardware Style Installation and Operation Manual,
publication 1747–NI001.
SLC 500 Modular Hardware Style Installation and Operation Manual,
publication 1747–NI002.
Advanced Programming Software (APS) User’s Manual,
publication 1747–NM002.
Important: Throughout this publication we use $ as the logical address
identifier. This is an entry for INTERCHANGE software. It is also an entry
for 6200 programming software in sending a message from other stations
to a SLC 500 processing station. It is not used in 6200 programming
software for internal addressing.
To Next Page
Loading...
