Allen-Bradley Studio 5000 Logix Emulate Programming Manual

Rockwell Automation Publication 1756-PM006I-EN-P - February 2018 59
Chapter 2
Program a sequential function chart
To add SFC elements, use the SFC toolbar.
1. On the SFC toolbar, click the button for the item that you want to add.
2. Drag the element to the required location on the SFC.
3. To wire (connect) two elements together, click a pin on one of the elements
and then click the pin on the other element . A green dot shows a
valid connection point.
Introduction
Add and manually connect
elements

Allen-Bradley Studio 5000 Logix Emulate Specifications

General

Brand	Allen-Bradley
Model	Studio 5000 Logix Emulate
Category	Controller
Language	English