12 Regulatory information
12.1 USA-Federal Communications Commission (FCC)
This device complies with part 15 of FCC rules. Operation is subject to the following two conditions: (1) This device may
not cause interference, and (2) this device must accept any interference, including interference that may cause
undesired operation of the device.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy. If not installed and used in
accordance with the instructions, it may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by tuning the equipment off and on, the user is encouraged to
try and correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the distance between the equipment and the receiver.
Connect the equipment to outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This portable equipment with its antenna complies with FCC’s radiation exposure limits set forth for an uncontrolled
environment. To maintain compliance, follow the instructions below:
(1) This transmitter must not be co-located or operating with any other antenna or transmitter;
(2) Avoid direct contact to the antenna, or keep contact to a minimum while using this equipment.
Notice to consumers:
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
12.2 Canada – Industry Canada (IC)
This device complies with Industry Canada’s license-exempt RSSs. Operation is subject to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation
of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes :
(1) L’appareil ne doit pas produire de brouillage ;
(2) L’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
This portable equipment with its antenna complies with RSS102’s radiation exposure limits set forth for an uncontrolled
environment. To maintain compliance, follow the instructions below :
(3) This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
(4) Avoid direct contact to the antenna, or keep contact to a minimum while using this equipment.
Cet équipement portable avec ses antennes est conforme aux limites d’expositions de la CNR102 applicables pour un
environnement non contrôlé. Pour maintenir la conformité suivez les instructions ci-dessous :
(3) Cet émetteur ne doit pas être co-localisé ou opérer en conjonction avec toute autre antenne ou émetteur.
(4) Évitez tout contact direct avec l'antenne ou gardez le contact au minimum pendant l'utilisation de cet
équipement.
To Next Page
Loading...
