Allflex AFX-110 - Operation and Settings; Getting Started; Battery Handling Instructions

4
3 Operation and settings
3.1 Getting Started
AFX-110 comes supplied with six AAA rechargeable NiMH battery pack (7.2 V / 750mAh) which must
be fully charged prior to use, as diagram below (step 1 through 5).
1
Remove retention screw located on center of
back of the reader.
2
Connect the battery pack to the connector.
3
Replace lid and screw.
4
Attach the power cord in the reader.
Plug the adaptor into power outlet. The battery level icon
will flash while
charging and stop flashing when fully charged. A full charge
may take 3.5 hours.
3.2 Battery handling instructions
Please read and follow the handling instructions for the battery before use. Improper use of the battery
may cause heat, fire, rupture, damage or capacity deterioration of the battery.
Caution
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES
ACCORDING TO THE INSTRUCTIONS.
Warning
Use rechargeable batteries with the same capacity.
Do not use this reader near water when connected to the AC/DC adapter.
Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus
that produce heat.
Do not charge the battery pack from AC main sources during electrical storms or when unused for
long periods of time.
The batteries must be charged indoors only, at temperature between 0° and +35°C.
For best battery performance, charge unit at least every three months, if reader is unused.
Notice
Use the adapter (AC Input: 100-240V, 50/60Hz, 0.4A; DC Output: 12.0V, 0.58A) provided with the
reader to charge the batteries.