Is the washer-extractor
anchored to a flat, level
surface with the proper
depth of concrete?
Run the
washer-extractor without
a load. If the problem persists,
it is not due to a fault with the
machine. Is the washer-
extractor grouted
properly?
Properly grout washer-extractor. Refer to
Installation Manual for specifications.
No
Yes
Yes
Remove and re-install washer-extractor correctly.
Refer to Installation Manual for specifications.
No
Are the front and rear
bearings making
excessive noise?
Replace the bearings as needed.
Yes
Lift up on the basket at the
front of the tub. Is there any
up and down play that would
indicate bearing wear?
No
Replace the bearings as needed.
Yes
Are motor and drive
pulleys aligned and
on tight?
No
Align/tighten pulleys as needed.
No
continued from
previous page
To Next Page
Loading...
