Alliance Laundry Systems NetMaster HC18NC2 - Page 136

Programming NetMaster
F232152
134
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
6. Press the START (enter) keypad to enter the fifth
digit and display remaining four digits. The
active digit will flash one second on and one
second off. Refer to Figure 220.
Figure 220
7. Press the DELICATES (+) or the COLD (-)
keypad to increase or decrease the value of the
active digit and the START (enter) keypad to
enter the value of the digit and advance to the
next digit.
8. Press the START (enter) keypad with the last
active digit. The next option, “+123”, will appear
in the VFD.
NOTE: To program “+123” (Error Code
Programming Parameter), refer to option 123. To
program other options, refer to the appropriate
section.
How to Exit Programming Feature
1. Be sure the control shows a programmable option,
not a value.
2. While pressing and holding the NORMAL
keypad with one hand, press the PERM PRESS
keypad with the other hand. The control will
revert back to the Ready Mode.
C828I
C828I