Alliance Laundry Systems NetMaster HC18NC2 - Page 69

Programming NetMaster
67
F232152
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Reading Table 10
Use the table below (Table 10) to turn “ON” or turn
“OFF” access for Manual Rapid Advance and
Diagnostics, Cool Down, and to change the Available
Output Mode.
NOTE: Cool Down is for specially equipped models
only.
Config. #3 Value Cool Down RADV/DIAG Access Available
0 Disabled OFF Ready Mode
1 Disabled OFF Until Start Mode
2Disabled ON Ready Mode
3Disabled ON Until Start Mode
4 Enabled OFF Ready Mode
5 Enabled OFF Until Start Mode
6 Enabled ON Ready Mode
7 Enabled ON Until Start Mode
Table 10