Alliance Laundry Systems SA025L - IR Access (On;Off) Ira

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Programming Control
63
70417701
30. IR Access (On/Off) “IrA”
This option allows the owner to enable or disable
allowing the control to be read by an external device.
How to Program the IR Access (On/Off)
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the LOW TEMP (∧) or the
DELICATES (∨) keypad until “Prog” appears
in the display. Press the START (enter) keypad
and “AtSH” will appear in the display.
3. Press the LOW TEMP (∧) or the
DELICATES (∨) keypad to scroll through the
programmable options until “IrA” appears in the
display.
4. When “IrA” appears in the display, press the
START (enter) keypad. The current IR Access
status will appear in the display.
“on” = Option Enabled
“oFF”= Option Disabled
NOTE: The default value is on.
5. Press the LOW TEMP (∧) or the
DELICATES (∨) keypad to change the current
status.
6. Press the START (enter) keypad when the
desired status appears in the display. The new
value is saved and the next option, “rAEn”, will
appear in the display.
NOTE: To program “rAEn” (Manual Rapid
Advance [On/Off]), refer to option 31. To program
other options, refer to the appropriate section.
How to Exit Programming Feature
Press the MED TEMP (<) keypad until the control
returns to Ready Mode.
31. Manual Rapid Advance (On/Off)
“rAEn”
This option allows the owner to enable or disable the
rapid advance feature. Refer to Rapid Advance
Feature section for more information.
How to Program the Manual Rapid
Advance (On/Off)
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the LOW TEMP (∧) or the
DELICATES (∨) keypad until “Prog” appears
in the display. Press the START (enter) keypad
and “AtSH” will appear in the display.
3. Press the LOW TEMP (∧) or the
DELICATES (∨) keypad to scroll through the
programmable options until “rAEn” appears in
the display.
4. When “rAEn” appears in the display, press the
START (enter) keypad. The current Manual
Rapid Advance status will appear in the display.
“on” = Option Enabled
“oFF”= Option Disabled
NOTE: The default value is on.
5. Press the LOW TEMP (∧) or the
DELICATES (∨) keypad to change the current
status.
6. Press the START (enter) keypad when the
desired status appears in the display. The new
value is saved and the next option, “dAEn”, will
appear in the display.
NOTE: To program “dAEn” (Manual Diagnostics
[On/Off]), refer to option 32. To program other
options, refer to the appropriate section.
How to Exit Programming Feature
Press the MED TEMP (<) keypad until the control
returns to Ready Mode.