© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
7
70417701
Display Identification
Light Emitting Diodes (LEDs)
(Refer to Figure 1)
LIGHT EMITTING DIODES (LEDs) are used to
indicate the chosen temperature and cycle status. See
below for information on each LED.
INSERT COINS/CARD LED
The INSERT COINS/CARD LED is lit to prompt the
user to insert coins or a card to satisfy the vend price
for the chosen cycle. The LED is lit during the
“Ready” mode. During Partial and Additional Vend,
the LED flashes one second on and one second off.
The INSERT COINS/CARD LED will shut off when
the vend price has been satisfied.
START LED
The START pad LED flashes whenever the dryer is
not in a cycle, the full vend price has been satisfied,
and the tumbler door is closed. When the START pad
is pressed, the cycle will begin or resume. The START
LED will shut off when the START pad is pressed.
The START LED will also flash any time a card is
inserted to add time to the current cycle.
DRYING LED
The DRYING LED is lit to indicate that one of the
heated cycles (HIGH TEMP, MED TEMP, LOW
TEMP, DELICATES) is currently in operation. The
DRYING LED goes off at the end of a heated cycle, if
the heated cycle is changed to a NO HEAT cycle, or
when the COOL DOWN cycle begins.
COOL DOWN LED
The COOL DOWN LED is lit whenever the COOL
DOWN portion of a heated cycle is active. It is also lit
when the NO HEAT cycle is in operation. The COOL
DOWN LED will shut off when a cycle ends or more
time is added, pushing the cycle back into the heated
portion of a cycle.
Four 7-Segment Digits
The 7-SEGMENT DIGITS are used to display the
time remaining in a cycle, vend price, error messages
and descriptive codes. During diagnostic testing or
manual programming of the control, these digits will
display descriptive codes and values (as described in
Entering the Manual Mode).
To Next Page
Loading...
