© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
70417701
6
Control Identification
SELECT CYCLE Pads
(Refer to Figure 1)
SELECT CYCLE pads are used to select the specific
tumbler cycle and temperature. These pads include
HIGH TEMP, MED TEMP, LOW TEMP,
DELICATES and NO HEAT. The selection of one of
these cycles will light up the corresponding LED. The
factory default cycle is MED TEMP.
START Pad
(Refer to Figure 1)
The START pad is used to start the tumbler after the
full vend price has been satisfied and the tumbler door is
closed.
Both the START pad and the SELECT CYCLE pads are
used in various combinations for programming cycles,
retrieving audit information, running diagnostic tests,
and other operations. During an active cycle (card reader
equipped machines only), the START pad may be
pressed (with a card inserted) to add time to a cycle.
Figure 1
DRY576R
1 Display
2 7-Segment Digits
3 START Pad
4 SELECT CYCLE Pads
5 LED Light
6 LED Status Lights
DRY576R
6
1
2
3
Electronic Control
5
4
To Next Page
Loading...
