Allied Telesis AT-x230-28GP - Leds; POWER and FAULT Leds; Figure 18: POWER LED on an X230 Series Switch; Table 5. POWER LED Functional Descriptions

AT-x230-10GT, AT-x230-10GP, AT-x230-18GT, AT-x230-18GP, AT-x230-28GT and AT-x230-28GP Switch Installation Guide
33
LEDs
This section describes the four types of LEDs on x230 Series switches:
 “POWER and FAULT LEDs” on page 33
 “10/1000BASE-T/100BASE-TX Link/Activity/Speed LED and PoE
status LED” on page 35
 “10/1000BASE-T/100BASE-TX Link/Activity/Speed LED and
Duplex/Collision LED” on page 37
 “SFP LEDs” on page 39
 “SD card LED” on page 40
POWER and
FAULT LEDs
The POWER LED reports the status of AC power and is located on the
front panel of the of the switches beside the console port. See Figure 18.
Note
All port LEDs are OFF when the switch is operating in the low power
mode. To toggle on the LEDs, use the ecofriendly button. See
“ecofriendly button” on page 42 for more information.
F
IGURE 18. POWER LED ON AN X230 SERIES SWITCH
Table 5 describes the POWER LED for x230 Series switches.
POWER LED
10GP
CONSOLE
RS-232
SD
FAULT
POWER
D
1000 LINK ACT 10/100 LINK ACT
2
1
ess Label
Power LED
TABLE 5. POWER LED FUNCTIONAL DESCRIPTIONS
LED State
Description
POWER
Off
Indicates either the switch is not receiving AC
power or the AC input power is operating outside
the normal range
Steady
green
The switch is receiving AC input power and is
operating normally