Allied Telesis AT-x230-28GP - Figure 40: Securing the AT-X230-10 GT Switch to the Wall with the Front Panel Facing up; Figure 41: Securing the AT-X230-10 GT Switch to the Wall with the Front Panel Facing Right

AT-x230-10GT, AT-x230-10GP, AT-x230-18GT, AT-x230-18GP, AT-x230-28GT and AT-x230-28GP Switch Installation Guide
67
FIGURE 40. SECURING THE AT-X230-10GT SWITCH TO THE WALL WITH THE FRONT PANEL FACING UP
FIGURE 41. SECURING THE AT-X230-10GT SWITCH TO THE WALL WITH THE FRONT PANEL FACING RIGHT
3. Slide the switch between the brackets so that it rests against the
bracket, as shown in the figures above.
4. Go to “Cabling the switch” on page 70.
Bracket position, viewed from above: Bracket position, viewed from below:
Bracket position,
viewed from below:
Bracket position,
viewed from above: