C613-50631-01 Rev A Command Reference for IE340 Series 1025
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
RIP COMMANDS
CISCO
-METRIC-BEHAVIOR (RIP)
cisco-metric-behavior (RIP)
Overview Use this command to enable or disable the RIP routing metric update to conform
to Cisco’s implementation. This command is provided to allow inter-operation
with older Cisco devices that do not conform to the RFC standard for RIP route
metrics.
Use the no variant of this command to disable this feature.
Syntax
cisco-metric-behavior {enable|disable}
no cisco-metric-behavior
Default By default, the Cisco metric-behavior is disabled.
Mode Router Configuration
Examples To enable the routing metric update to behave as per the Cisco implementation,
enter the commands:
awplus# configure terminal
awplus(config)# router rip
awplus(config-router)# cisco-metric-behavior enable
To disable the routing metric update to behave as per the default setting, enter the
commands:
awplus# configure terminal
awplus(config)# router rip
awplus(config-router)# no cisco-metric-behavior
Validation
Commands
show running-config
Parameter Description
enable Enables updating the metric consistent with Cisco.
disable Disables updating the metric consistent with Cisco.
To Next Page
Loading...
Need help?
General
