76Alvium USB Cameras User Guide V3.6.4
Specifications
ROI frame rates
Values were calculated as defined in Specified values on page 51.
To reach the maximum frame rate available for this setup, the bandwidth for image
traffic is 200 MBps. Increasing the
DeviceLinkThroughputLimit value does not
increase frame rates.
Image format
Width
[pixels]
Height
[pixels]
ROI area
[MP]
Frame rate [fps]
1
450 MBps 375 MBps 200 MBps
Full resolution 1296 1032 1.337 128 / 119 / 69 128 / 70 / 69
SXGA 1280 1024 1.311 129 / 120 / 69 129 / 71 / 69
HD 720 1280 720 0.922 178 / 165 / 96 178 / 99 / 96
XGA 1024 768 0.786 168 / 156 / 91 168 / 115 / 91
SVGA 800 600 0.480 211 / 196 / 114 211 / 185 / 114
VGA 640 480 0.307 258 / 239 / 140
HVGA 480 320 0.154 364 / 339 / 199
QVGA 320 240 0.077 460 / 429 / 253
HQVGA 240 160 0.038 623 / 581 / 348
QQVGA 160 120 0.019 755 / 709 / 428
Max. × half 1296 516 0.669 237 / 220 / 129 237 / 131 / 129
Max. × min. 1296 8 0.010 1622 / 1506 / 1025
1622 / 1054 /
1025
Min. × max. 8 1032 0.008 129 / 120 / 69
Min. × min. 8 8 64 pixels 1903 / 1816 / 1186
1
Mono8 at SensorBitDepth = 8-Bit
(2)
/ Mono10 at SensorBitDepth = 10-Bit /
Mono12 or at
SensorBitDepth = 12-Bit
2
The SensorBitDepth value must be set separately from PixelFormat.
See Sensor ADC readout modes for maximum frame rates on page 52 for details.
Table 27: Alvium 1800 U-130 VSWIR ROI frame rates
To Next Page
Loading...
