Alpine 7294R - Page 12

me) )5:7-Wale)\\
Preset Memory Programming
Follow the instructions below to enter stations into preset memory:
1. Select the tuning band (FM1, FM2, MW or LW) with the BAND button @.
2. Tune in your desired station using Manual or Auto SEEK tuning.
3. Press the Preset button number 1 @® for more than two seconds. The digital display
will begin to blink. Press that preset button again while the display is blinking (within 5
seconds).
4. The frequency you selected will be placed into Preset Memory number 1 and will
appear in the display.
NOTE:
If a preset memory has already been set in the same address, it will be cleared and
the new station will be memorized.
5. Follow steps 2 — 3 for the remaining presets (2 — 6). This procedure should be
followed for FM1, FM2, MW and LW.
Auto MEMOry Preset
1. Press the TUNE switch © to light up the A. MEMO indicator @.
2. Select the desired tuning band (FM1, FM2, MW or LW) with the BAND button @.
3. Press the UP ® or DN © switch. The tuner will automatically seek the 6 strongest
stations in each band and memorize them in order of the signal strength. These
stations are automatically placed in the preset memory with the strongest station in
Preset No. 1 and the 6th strongest station in Preset No. 6. When seeking stations, the
tuner first seeks in the local tuning mode. If less than 6 stations are memorized, the
tuner seeks again in the distance (DX) mode.
4. After finishing the Auto Memory Preset, the tuner goes to the station placed in Preset
Memory No. 1. If no stations are memorized, it returns to the original station you were
listening to before the Auto Memory Preset procedure began. When auto memory
presetting is completed, the A. MEMO indicator @ will disappear and the SEEK
indicator @) will appear.
NOTE:
The Auto Memory Preset feature also works in the D.A.P. mode.
Preset Tuning
After
the
preset
stations
have
been
memorized,
you
can
tune
in
your
desired
station
(within the band displayed) with one touch of a button.
1.
Select
the
tuning
band
(FM1,
FM2,
MW
or
LW)
with
the
BAND
button
4.
2. Press any one of the Preset buttons (@2 — @) and the indicator on that button will light.
3.
The
frequency
of
the
station
placed
in
the
selected
preset
location
will
appear
in
the
display.
D.A.P. (Direct Access Preset)
This
feature
allows
the
storage
of
FM,
MW
and
LW
presets
on
the
same
band.
Press
the
D.A.P.
button
@
to
light
up
the
D.A.P.
indicator
@.
To
program
stations
into
the
D.A.P.
band,
follow
steps
1
—
3
as
described
in
the
Preset
Memory
Programming
section
above.
Accessing the D.A.P. Presets
1.
Press
the
D.A.P.
button
®.
The
D.A-P.
indicator
®
will
illuminate
in
the
display.
2. Press one of the preset buttons (42 — @).
3.
The
frequency
of
the
station
placed
in
the
selected
D.A-P.
location
will
appear
in
the
display.
12