Alpine 7294R - Basic Operation

fo) 3:7 Wee) ee
@ BASIC OPERATION
Initial System Start
When operating the system for the first time after installation or after the vehicle’s
battery
has
been
disconnected
and
reconnected,
set
the
volume
level
to
its
minimum,
then
carefully
press
the
Reset
switch
$3
with
a
sharp
pencil
or
any
other
pointed
object.
How
to
adjust
the
volume
and
tone
(Refer
to
the
diagram
in
next
page.)
1. Press the POWER on/off switch 8 to turn the unit on.
2. Press the Audio MODE Select switch 64 to select each adjusting mode.
VOL > TREB ~ BASS ~ BAL > VOL ::--:
Everytime
this
switch
is
pressed,
the
mode
changes.
Each
mode
indicator
is
then
On.
The
mode
indicator
changes
as
each
mode is
selected.
3.
Once
the
desired
mode
appears
in
the
display,
rotate
the
Audio
MODE
Select
switch
to
make
your
adjustment.
The
display
will
return
to
the
previous
mode
indication
after
five
seconds.
Power Off
Press the POWER on/off switch @4 to turn the unit off for more than two seconds.
LOUDness
Press the LOUD button @ for more than two seconds to activate the loudness function.
Press the LOUD button @ for more than two seconds again to defeat this feature.
Mode Switching of the 7294R
1. Radio Mode
Press the TUNER button 40 to put the unit into the radio mode. The Band indicator
(F1, F2 or MW or LW) and the frequency will appear in the display 48.
2. Cassette Player Mode
Press the TAPE button @ to put the unit into the cassette player mode.
3. CD Shuttle Mode
Press the DISC button ® to put the unit into the CD mode.
Five Modes Setting Function
This unit allows setting of five modes shown below. For further details, refer to the
Gescription on each mode.
FM level switching.
Sound volume setting during reception of traffic information.
Operation switching when a traffic information station is not received.
Operation switching for Q.R.B. Minder.
Switching of automatic tracing function. (Station name display & automatic tracing
function/station name display only.)
* * + *