2.14
ENG_UD70774_5
Fonction Stop and Start (XEF - Alpine)
STOP AND START FUNCTION (4/4)
Special feature of the automatic
engine re-start
Under certain conditions, the engine
can restart on its own in order to guar-
antee your safety and comfort.
This can occur especially when:
– the outdoor temperature is too low or
too high;
– the “Clear View” function is activated
(please see “Automatic Climate
Control” in Section 3);
– the battery is not sufficiently charged;
– the vehicle speed is above 3 mph
(5 km/h) (downhill slope, etc.);
– repeated pressing on the brake
pedal or braking system require-
ment;
– ...
Deactivating, activating the
function
Press 1 to deactivate the function. The
message “Stop & Start Deactivated”
appears on the instrument panel and
the ignition warning light 1 appears.
Pressing again will reactivate the
system. The message “Stop & Start
Activated” appears on the instrument
panel and the 1 switch disappears.
The system reactivates automati-
cally each time the vehicle is started
using the start button (please refer
to “Starting, stopping the engine” in
Section 2).
Operating faults
When the “Check Stop & Start” mes-
sage appears on the instrument panel
and the 1 switch is on, this indicates
that the system is deactivated.
Please consult an authorised dealer.
Before leaving the vehicle,
the engine must be stopped
and not put on standby
(please see the information
on “Starting, stopping the engine” in
Section 2).
Special note: with the engine on
standby, press switch 1 to automati-
cally restart the engine.
1
To Next Page
Loading...