2.13
ENG_UD70774_5
Fonction Stop and Start (XEF - Alpine)
STOP AND START FUNCTION (3/4)
Conditions preventing the
standby of the engine
Certain conditions prevent the system
from using the engine standby function,
including when:
– reverse gear is engaged;
– the driver’s door is not closed;
– the driver’s seatbelt is not fastened;
– the outdoor temperature is too low or
too high;
– the battery is not sufficiently charged;
– the difference between the vehicle
interior temperature and the auto-
matic climate control instruction is
too high;
– driving mode Sport or Track is ac-
tivated (please refer to “Choice of
driving mode” in Section 2);
– the altitude is too high;
– the gradient is too steep;
– the “Clear View” function is activated
(please see “Automatic climate con-
trol” in Section 3);
– the engine temperature is too low;
– ...
Warning light
is displayed on the
instrument panel. This notifies you that
engine standby is not available.
Deactivate the Stop and
Start function for any opera-
tion performed in the engine
compartment.
Special cases
With the engine on standby (traffic jam,
traffic lights, etc.), if the driver unfastens
their seat belt, opens the driver’s door
or gets out of their seat, the ignition will
be switched off.
The handbrake is applied automatically.
To restart and reactivate the Stop and
Start system, start the engine (please
refer to the information on "Starting,
stopping the engine" in Section 2).
To Next Page
Loading...