2.46
ENG_UD52290_3
Boîte automatique (XEF - Alpine)
AUTOMATIC TRANSMISSION (2/7)
To disengage the “Parking”
position (P)
With the vehicle at a standstill, engine
running, depress the brake pedal and
select the desired position (R), (N), (M)
or (D).
Gearbox positions (R), (N), (D) or (M)
should only be engaged when the
vehicle is stopped, with your foot on
the brake, the accelerator pedal re-
leased and the engine running.
If the brake pedal is not fully depressed,
the 3 warning light appears on the in-
strument panel.
Note:
– If the driver opens their door to leave
the vehicle while position (P) has not
been engaged, a beep sounds and
the message “P not engaged” is dis-
played on the instrument panel.
– The warning light 3 appears each
time it is necessary to depress the
brake pedal to change the automatic
gearbox position.
4
3
To engage the “Parking”
position (P)
With the vehicle stationary, engine run-
ning or the ignition on, press and hold
the switch N until the indicator light in-
tegrated into switch N appears in red.
P is displayed on the instrument panel.
The gearbox switches to parking posi-
tion (P).
Note: when the engine is switched off
by pressing the button, position (P) is
automatically engaged as well as the
electronic parking brake, for those vehi-
cles equipped with it. The indicator light
on the N control appears in red and P is
displayed on the instrument panel.
Check that warning light P
on the instrument panel and
the red warning light inte-
grated into the N switch are
activated before leaving the vehicle.
Risk of loss of immobilisation of
the vehicle
If the message “Check auto
gearbox” or “Electric fail-
ure DANGER” is displayed,
or in the event of a battery
fault, immobilise the vehicle using
the electronic parking brake.
Contact an approved dealer as soon
as possible.
When you select position (D), (M) or
(R), the vehicle moves forward as
soon as you release the brake pedal
(without pressing on the accelerator
pedal).
To Next Page
Loading...