5.21
ENG_UD54130_3
Batterie : dépannage (XEF - Alpine)
BATTERY: troubleshooting (2/4)
Starting the vehicle using the
battery from another vehicle
If you have to use the battery from an-
other vehicle to start, obtain suitable
jump leads (with a large cross section)
from an approved dealer or, if you al-
ready have jump leads, ensure that
they are in perfect condition.
The two batteries must have an iden-
tical nominal voltage of 12 volts. The
battery supplying the current should
have a capacity (amp-hours, Ah) which
is at least the same as that of the dis-
charged battery.
Ensure that there is no risk of contact
between the two vehicles (risk of short
circuiting when the positive terminals
are connected) and that the discharged
battery is properly connected. Switch
off your vehicle ignition.
3
B
C
Depending on the vehicle, it may be
necessary to remove the scuttle panel
grille run channel to access the battery.
To do this:
– hold by the rear end the wing 1 of the
scuttle panel grille run channel 3 and
pull it upwards to unclip it from the
scuttle panel grille 2;
– take hold of the run channel on the
left-hand side then pull it upwards to-
wards you (movement B) to unclip it
fully;
– move to the left (movement C) to re-
lease the right-hand side of the run
channel and facilitate its movement
in relation to the strut;
– place the run channel 3 gently on a
clean and dry surface.
1
2
A
Vehicles not fitted with
storage compartment A
Due to the presence of me-
chanical components:
– it is forbidden to store objects
under the bonnet;
– when working on the engine
compartment, ensure that you do
not leave anything (cloths, tools,
etc.) Otherwise, this may lead
to the mechanical components
being damaged or cause a fire.
Risk of damage or fire;
– When working in the engine com-
partment, the mechanical com-
ponents may be hot. In addition,
the engine cooling fan may start
at any moment.
Risk of injury.
To Next Page
Loading...