5.34
ENG_UD56137_2
Anomalies de fonctionnement (XEF - Alpine)
OPERATING FAULTS (2/6)
The starter is activated POSSIBLE CAUSES ACTION REQUIRED
The instrument panel indicator lights
are weak or fail to light up and the
starter does not turn.
Battery terminals not tight, bat-
tery terminals disconnected or
oxidised.
Retighten or reconnect the terminals, or clean them if
they are oxidised.
Discharged battery or not op-
erational.
Connect another battery to the faulty battery. Refer to
the paragraph “Battery: troubleshooting” in section 5
or replace the battery if necessary.
Do not push the vehicle if the steering column is
locked.
Faulty circuit. Consult an approved dealer.
The engine will not start. Starting conditions are not ful-
filled.
Please refer to the information on “Starting, stopping
the engine” in Section 2.
The “hands-free” card does not
work.
Insert the card in the card reader in order to start the
engine.
Please refer to the information on “Starting, stopping
the engine” in Section 2.
With the vehicle stationary, engine
cold, the engine’s idle speed is high.
This is not necessarily a fault.
This may be caused by the in-
crease in the engine tempera-
ture.
The engine’s idle speed should decrease after about
one minute. Otherwise, this may be caused by another
fault. Consult an approved dealer.
The engine cannot be switched off. Card not detected. Insert the card in card reader.
Electronic fault. Press the starter button quickly five times.
The steering column remains locked. Steering wheel locked. Move the steering wheel while pressing the engine
start button (please refer to Section 2 “Starting, stop-
ping the engine”).
Faulty electrical circuit. Consult an approved dealer.
To Next Page
Loading...