Alpine A110 - Page 53

LISTEN TO THE RADIO
3
Audio/Multimedia - 51
"Presets" mode
This mode enables you to recall stored
stations.
For more information, refer to the
"Save preset" paragraph in this
section.
Press one of the buttons 14 to select
the radio station that you wish to listen
to.
For safety reasons, carry
out these operations
when the vehicle is
stationary.
Pop-up menu 6
Use the pop-up menu 6 in any mode
to go to the settings and configure the
following radio functions:
– « Radio settings » ;
– "Sound equaliser settings";
– "Sound settings".
For more information, refer to the
Settings" section.
«Radiosettings»
From the settings, you can activate or
deactivate the following elements:
– « AM » ;
– « Radio text » ;
– « Region » ;
– « TA/I-Traffic » ;
– "Logo";
– « HD radio";
– ...
« AM »
You can enable/disable the waveband
display AM in the audio sources menu
list 10 by pressing "ON" or "OFF".
« Radio text »
(text information)
Some FM radio stations broadcast text
information relating to their
programmes (e.g. song titles). Activate
this function if you would like to see
these details.
Note: this information is only available
for some radio stations.
« Region »
The frequency of an "FM" radio station
may change depending on the
geographical area. Activate this
function to continue listening to the
same radio station whilst changing
region. The audio system will
automatically track frequency changes
without interruption.
When "Region" mode is deactivated, if
the signal level drops, the radio will
switch to a new frequency operating as
a relay for the station you were
listening to previously.
Note: