Alpine CDA-7998R User Manual

13-EN
Adjusting and Storing the Time
Correction
Before performing the following procedures, refer to
"About the Time Correction" (page 11).
1 Make time corrections by pressing the T.CORR button.
Each press changes the modes as follows:
→ Bass Focus mode → Time correction mode
Normal mode ←
2 Select a speaker to be adjusted by pressing the BAND
button.
→ F – L → F – R → R – L → R – R → SW L → SW R
3 Adjust the desired time correction value by turning the
Rotary encoder.
To store the adjusted contents
1) Press and hold any one of the Preset buttons (1
through 6) for at least 2 seconds into which you
wish to store the adjusted curve.
4 For setting another speaker, repeat the step 2 and 3.
5 After setting, press the MODE button to return to the
normal mode.
NOTES
• Time Correction mode is automatically cancelled if no
buttons are pressed within 15 seconds.
• To cancel Time Correction mode for all music source, press
and hold the T.CORR button for at least 3 seconds to turn
Time Correction off.
• When the ALPINE Digital Audio Processor is connected to
the Digital Output Connector, the Equalizer, Crossover, Bass
Focus, Time Correction and MX (Media Xpander) functions
cannot be used in the built-in CD mode.
The functions on the connected Digital Audio Processor side
take preference.
Time Difference Table
0 0.0 14 1.4 28 2.8
1 0.1 15 1.5 29 2.9
2 0.2 16 1.6 30 3.0
3 0.3 17 1.7 31 3.1
4 0.4 18 1.8 32 3.2
5 0.5 19 1.9 33 3.3
6 0.6 20 2.0 34 3.4
7 0.7 21 2.1 35 3.5
8 0.8 22 2.2 36 3.6
9 0.9 23 2.3 37 3.7
10 1.0 24 2.4 38 3.8
11 1.1 25 2.5 39 3.9
12 1.2 26 2.6 40 - 98 4.0 - 9.8
13 1.3 27 2.7 99 9.9
Number of
Steps
Time
Difference
(ms)
Number of
Steps
Time
Difference
(ms)
Number of
Steps
Time
Difference
(ms)
Recalling the Stored Time Correction
Settings
1 Make time corrections by pressing the T.CORR button.
Each press changes the modes as follows:
2 Press the any one of the Preset buttons (1 through 6)
that have your desired time correction in memory.
3 Press the MODE button to return to the normal mode.
NOTES
• Time Correction mode is automatically cancelled if no
buttons are pressed within 15 seconds.
• To cancel Time Correction mode for all music source, press
and hold the T.CORR button for at least 3 seconds to turn
Time Correction off.
• When the ALPINE Digital Audio Processor is connected to
the Digital Output Connector, the Equalizer, Crossover, Bass
Focus, Time Correction and MX (Media Xpander) functions
cannot be used in the built-in CD mode.
The functions on the connected Digital Audio Processor side
take preference.
→ Bass Focus mode → Time correction mode
Normal mode ←

Alpine CDA-7998R Specifications

General

Brand	Alpine
Model	CDA-7998R
Category	Car Receiver
Language	English