28-EN
Adjusting Source Signal Levels
If the difference in volume level between the CD player
and FM radio is too great, adjust the FM signal level as
follows.
1 Press and hold the SETUP button for at least 3
seconds.
2 Press the g DN or f UP button to select the FM
LEVEL mode.
3 Press the BAND button to select the FM signal level Hi
(High) or Lo (Low) to make the signal levels between
the FM band and CD player closer.
NOTE
The initial setting at the factory is "HIGH."
4 Press the SETUP button to return to normal mode.
Switching the Tuner Mode
The CDA-7998R incorporates the MAX TUNE Pro for
the highest quality tuner audio. Moreover, you can
choose between 3 settings to suit your own personal
sound preferences usage.
1 Press and hold the SETUP button for at least 3
seconds.
2 Press the g DN or f UP button to select
"TUNER SELECT MODE."
3 Press the BAND button to switch the TUNER mode.
NORMAL : Standard setting
Hi-Fi : Sound quality priority setting
STABLE : Noiseless priority setting
BAND
f UP
g DN
SETUP
NOTES
• The initial setting at the factory is "NORMAL."
• If you find the sound is very noisy while listening to the
tuner in the Hi-Fi mode, we recommend you change to the
NORMAL mode.
4 When the setting is completed, press the SETUP
button to return to the normal mode.
Changing Lighting Colour
1 Press and hold the SETUP button for at least 3
seconds.
2 Press the f UP or g DN button to select
“AMBER."
3
Press the BAND button to toggle the mode between
AMBER ON (amber) and AMBER OFF (green).
NOTE
The initial setting at the factory is "AMBER OFF."
4 Press the SETUP button to set the selected mode.
Subwoofer On and Off
1 Press and hold the SETUP button for at least 3
seconds.
2 Press the g DN or f UP button to select the
Subwoofer mode.
3 Press the BAND button to select Subwoofer ON or
OFF.
4 Press the SETUP button after setting the Subwoofer
ON.
5 Press the MODE button repeatedly to select the
Subwoofer mode.
Press the g DN or f UP button after selecting the
Subwoofer mode, and the subwoofer output phase is
toggled "PHASE 0° " or "PHASE 180°."
6 Turn the Rotary encoder until the desired sound is
obtained in each mode.
NOTES
• The initial setting at the factory is "Subwoofer ON."
• Set to "Subwoofer OFF" unless the subwoofer is used.
→ NORMAL → Hi-Fi → STABLE
SETUP Operation
→ Subwoofer → BALANCE
VOLUME ← DEFEAT ← FADER ←
MODE Rotary encoder
To Next Page
Loading...
Need help?
General
