Alpine CDE-135EBT User Manual

9-EN
Presetting Stations Automatically
1 Press BAND repeatedly until the desired radio band is
displayed.
2 Press and hold TUNEA.ME for at least 2 seconds.
The frequency on the display continues to change while the
automatic memory is in progress. The tuner will automatically
seek and store 6 strong stations in the selected band. They will
be stored into preset buttons 1 to 6 in order of signal strength.
When the automatic memory has been completed, the tuner
goes to the station stored in preset location No.1.
Note
• If no stations are stored, the tuner will return to the original station you
were listening to before the auto memory procedure began.
Tuning to Preset Stations
Select the band, and then press any one of the station
preset buttons (1 through 6) that has your desired radio
station in memory.
The display shows the band, preset number and frequency of
the station selected.
Frequency Search Function
You can search for a radio station by its frequency.
1 Press and hold ENTER for at least 2 seconds in Radio
mode to activate Frequency search mode.
2 Turn the Rotary encoder to select the desired frequency.
3 Press ENTER to receive the selected frequency.
Note
•Press  in the search mode to cancel. Or, the search mode will be
cancelled if no operation is performed for 10 seconds.
* The illustration is for CDE-135EBT.
Playback
1 Insert a disc with the label side facing up.
The disc will be pulled into the unit automatically.
Note
• When a disc is already inserted, press SOURCE to switch to the
DISC mode.
2 While playing back MP3/WMA/AAC, press  or  to select
the desired folder.
3 Press  or  to select the desired track (file).
Pressing and holding  or  will fast backward/fast
forward track continuously.
4 To pause playback, press .
Pressing  again will resume playback.
5 To eject the disc, press .
Notes
• Do not remove a CD during its eject cycle. Do not load more than one
disc at a time. A malfunction may result from doing either.
•The “” indicator lights up when a disc is inserted.
• Three-inch (8 cm) CDs can not be used.
• Any file protected by DRM (Digital Rights Management) copy
protection, cannot be played back on this unit.
• The track display for MP3/WMA/AAC data playback is the file
numbers recorded on the disc.
• The playback time may not be correctly displayed when a VBR
(Variable Bit Rate) recorded file is played back.
CD/MP3/WMA/AAC


SOURCE/



Rotary encoder//ENTER
4 5
00ALPINE.book Page 9 Sunday, November 20, 2011 6:35 PM

Alpine CDE-135EBT Specifications

General

Brand	Alpine
Model	CDE-135EBT
Category	Car Receiver
Language	English