Alpine CDE-135EBT User Manual

32-EN
•Mechanism error.
1 Press the  button and eject the CD.
If not ejecting, consult your Alpine dealer.
2 When the error indication remains after ejecting, press the 
button again.
If the error indication still does not turn off after pressing the 
button for a few times, consult your Alpine dealer.
• When “ERROR” is displayed:
If the disc cannot be ejected by pressing , press the RESET switch
(Refer to “Initial System Start-Up” on page 7) and press  again.
If the disc still cannot be ejected, consult your Alpine dealer.
• A copy-protected WMA file was played back.
– You can only play back non-copy-protected files.
• A sampling rate/bit rate not supported by the unit is used.
– Use a sampling rate/bit rate that is supported by the unit.
• Database error or decoder error.
– You can solve the problem by switching the source.
• Communication error or boot error, etc.
– You can solve the problem by reconnecting the USB Memory or
changing source.
• Abnormal current is run to the USB Flash Memory connector device.
– You can solve the problem by switching the source.
• No song (file) is stored in the USB Memory.
– Connect the USB Memory device/Portable audio player after
storing songs (files).
• A sampling rate/bit rate not supported by the unit is used.
– Use a sampling rate/bit rate that is supported by the unit.
• A copy-protected WMA file was played back.
– You can only play back non-copy-protected files.
• Text information that is not recognizable by the unit is being used.
– Change the text information to test that is supported by the unit.
• The BLUETOOTH device is not connected.
– Connect the BLUETOOTH device.
• There are no songs in the iPod/iPhone.
– Download songs to the iPod/iPhone.
• Database error or decoder error.
–Replace the iPod.
• Communication error or boot error, etc.
– You can solve the problem by reconnecting the iPod/iPhone or
using a different iPod/iPhone.
• The iPod/iPhone is not verified.
– You can solve the problem by reconnecting the iPod/iPhone.
• Abnormal current is run to the USB connector device.
– You can solve the problem by switching the source.
Indication for USB Memory
or
BLUETOOTH mode
Indication for iPod Mode
NO SUPPORT
00ALPINE.book Page 32 Sunday, November 20, 2011 6:35 PM

Alpine CDE-135EBT Specifications

General

Brand	Alpine
Model	CDE-135EBT
Category	Car Receiver
Language	English