EasyManua.ls Logo

Alpine MRV-M1200 - Amplifier Installation Guide; Mounting and Drilling

Alpine MRV-M1200
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ALPINE MRV-M1200 68-29530Z91-A (EN/FR/ES)
3-EN
EN
FR
ES
INSTALLATION
Due to the high power output of the MRV-M1200
considerable heat is produced when the amplifier
is in operation. For this reason, the amplifier should
be mounted in a location which will allow for free
circulation of air, such as inside the trunk. For
alternate installation locations, please contact your
authorized Alpine dealer.
1. Using the amplifier as a template, mark the four
screw locations.
2. Make sure there are no objects behind the
surface that may become damaged during
drilling.
3. Drill the screw holes.
4. Position the MRV-M1200 over the screw holes,
and secure with four self-tapping screws.
Self-Tapping Screws (M4 × 20)
Holes
Holes
Chassis
Ground Lead
NOTE:
To securely connect the ground lead, use an
already installed screw on a metal part of the
vehicle (marked ( )) or a clean, bare metal spot
on the vehicles chassis. Be sure this is a good
ground by checking continuity to the battery (–)
terminal. Connect all equipment to the same
ground point while keeping wire length as short
as possible. These procedures will help eliminate
noise.
5. Attach the Remote Bass Control Unit.
Attach the Remote Bass Control Unit under the
instrument panel or side of the front console,
etc., by using the four supplied Self-Tapping
Screws.
Self-Tapping Screws (M4 × 12)
CAUTION
DO NOT ALLOW CABLES TO BECOME ENTANGLED
IN SURROUNDING OBJECTS. Cables or wiring that
obstruct or hang up on places such as the steering
wheel, gear lever, brake pedals, etc. can be
extremely hazardous.
ATTACHING THE
TERMINAL COVERS
Attach the terminal covers (included) after
connections and confirmation of correct operation.
Attaching the terminal covers will improve the
appearance of the unit.
How to attach the terminal covers:
Attach the terminal covers to the main unit.
Terminal Covers
CAUTION
Do not lift or carry the unit by the attached
terminal covers.
und to
ing
s in
pment
y, and it
ordance
nit in
e is
anty,
which
d States
r dealer
ge.
..............4
......1 SET
..............1
..............1
......1 SET
..............1
..............4

Other manuals for Alpine MRV-M1200

Related product manuals