To Next PageTo Next Page
Need help?Do you have a question about the Alpine S2-A36F and is the answer not in the manual?
Configure input signal type and amplifier turn-on method (DC, REM).
Set amplifier gain to match head unit volume for optimal sound.
Adjusts crossover frequency (50 Hz - 400 Hz) for HPF/LPF filters.
Adds bass boost (+12 dB) at 50 Hz or 100 Hz for bass response tuning.
Selects OFF, HP, or LP filter mode for speaker output.
Selects 2-channel or 4-channel input mode or SUBwoofer signal.
Illustrates basic wiring for the S2-A36F amplifier with speakers.
Diagrams for connecting speaker systems to the amplifier.
Wiring diagram for bridged connections with speakers and subwoofer.
Wiring diagram for connecting two speakers in bridged mode.
Illustrates basic wiring for S2-A55V based on input channels.
Guides for setting input channel selectors based on speaker input.
Wiring for a 4 speaker plus subwoofer setup.
Diagrams for series and parallel connections of dual voice coil subwoofers.
Wiring for a 2 speaker plus subwoofer system in bridged mode.
Instructions for connecting using the Speaker-RCA Conversion Cable.
Guidance on using Y-adapters for single output head units.
Specifies wire size and external fuse capacity based on amplifier setup.
Example wiring for installing a single amplifier alone.
Example wiring for installing multiple amplifiers with a distribution block.
Detailed performance and general specifications for the S2-A36F amplifier.
Detailed performance specs for the S2-A55V amplifier, including power output and THD+N.
Input sensitivity, crossover, impedance, dimensions, and weight for S2-A55V.
General
