Alpine TDA-7567R - Remote Control Battery Replacement

108
EnglishEnglish
English/Français/Español
Remote Control
(RUE-4180 supplied with TDA-7567R)
Battery Replacement
Applicable battery: Use one CR2025 or
equivalent.
1
2
C
R
2
0
2
5
Replacing the battery
Put the battery in the case with the (+) indication
upward as shown in the illustration.
Closing the case
Push the battery holder back into the remote
until a click is heard.
Opening the battery case
1 Place the remote upside down on a flat,
level surface.
Looking at the back of the remote, grasp
the battery holder at the bottom of the unit
between your forefinger and thumb. Insert
a pointed object into the left side of the
elongated hole.
Slide the pointed object to the right (as
indicated by the arrow) while at the same
time pulling on the battery holder.
2 Pull the rear cover out with your thumb at
the same time.