Alpine TDA-7567R - Adjusting Source Signal Levels

24
English
Basic Operation
Press and hold the PWR button for at least 3
seconds.
1
Adjusting Source Signal
Levels
If the difference in volume level between the
tape player and FM radio is too great, adjust
the FM signal level as follows.
Press the F1 button to select the FM signal level
HI (High) or LO (Low) to make the signal levels
between the FM band and tape player closer.
Press the PWR button to cancel the adjusting
mode.
3
F1
FM-LV HI
FM-LV LO
2
INTLZ
PWR
INTLZ
PWR