User Manual M2x2/EN M/F
iSTAT M2x2
Page 32
Info
Figure 11-8
Product Information
Ser.#: MCxxxxxx
S.ver: 0.29
H.ver: A
Date: 14.08.2009
Run: 0d 14h 47’
<- Main Menu
Back to main menu
The information shown on the Product Information display is:
Ser.#: MCxxxxxx: this is M2x2 serial number.
S.ver: 0.29: this is the software version loaded in the M2x2
H.ver: A this is the hardware version of the M2x2
Date: 14.08.2009: this is the date that the M2x2 was calibrated
Run: 0d 14h 47’: this is time that the M2x2 has been operating since calibration
10.6 Installation Navigation
Figure 11-9 illustrates the Installation menu structure. The user presses OK key to make a
selection. The LEFT key is pressed to return to the Main Menu.
Installation
Figure 11-9
Welcome to the
Installation wizard.
Press OK to continue
Installation Wizard display
<- Main Menu
Back to main menu
The Installation Wizard is described in section 12.1
10.7 Default settings
The M
2x2 is supplied with the following default settings. Changes to these settings can be
made on the front menu or via remote communications. It is recommended that the setup
wizard is used to enable basic configuration.
Language
English
Mode, CT and VT
1b, not set
Password
None set (L1 = AAAA)
Counters and registers
Set to zero
Communication
19200 bps, address 33, parity none, stop bit 2
To Next Page
Loading...