User Manual M2x2/EN M/F
iSTAT M2x2
Page 36
Figure 12-1 shows the Stop Bit setting structure. Changes are made by pressing either the
DOWN or UP keys until the desired setting is shown, then press OK key to confirm. The
LEFT key can be pressed to return to the Parity setting.
Stop Bit
Figure 12-11
1
2
Stop Bit display
OK Select
Figure 12-2 shows the Installation Completed display. Press OK key to confirm all the
changes and complete the installation.
Installation
Figure 12-12
Installation
Completed
Installation Complete display
OK Main Menu
Back to main menu
11.2 Demo Cycling
The fun
ction polls through a number of different displays that show the different features that
are in the M2x2.
Figure 12-3 illustrates the measurement menu structure. The user can browse through the
available menus using the direction keys, by pressing either the DOWNor UP keys and
then pressing the OK key to select the Demo Cycling Menu.
Measurements
Figure 12-13
Menu name
Present Values
Alarms
Demo Cycling
Measurements display
<- Main Menu
Back to main menu
Figure 12-4 illustrates the Demo Cycling setting. The user presses the OK key to activate the
Demo Cycling feature.
Measurements
Figure 12-14
Menu name
Cycling Period
4 sec,
Press OK
Demo Cycling setting
<- Measurements
Back to measurement menu
To Next Page
Loading...